Our RBH rear frame visually continues the original round tube frame of the RnineT and closes the rear with a Caferacer-typical frame loop, which gives the RnineT a very unique effect. The original cast aluminum triangles are omitted, which makes the seat area look tidier.We also have the matching, ready upholstered seat in the program, alternatively we also offer the unupholstered seat base plate, which you can have individually covered by the saddler of your choice.
If you do not want to combine our rear frame with our central license plate holder ( see accessories ) but our side one, you can attach turn signal holders ( included ) in the rear area of the enclosed base plate. The base plate has suitable for this in the area of the turn signals cable grommets to lead the turn signal cable hidden upwards.
If you decide for our version without recessed taillight, can of course also be used here 3 in 1 turn signals. ( see accessories ) The turn signal holders have an 8mm hole, so are suitable for the common accessories turn signals.
In addition, the bottom plate relocates the control unit sitting in the front area and the OBD connector a bit further up. The integrated brackets ensure a tidy, clearly structured cable routing and hold the components securely in their new place. This allows the bottom panel to be flush with the bottom edge of the rear frame.
As mentioned above, we offer our RBH rear frame in different versions. Besides a version without tail light, there are 3 versions with integrated tail light.
Rear light version MONO:
Recessed round LED taillight with 18mm diameter. Very discreet, yet extremely bright, of course with integrated brake light. With ABE.
Taillight version SHORTY:
Recessed 50mm wide and 8.5mm high SMD Technology based LED taillight / brake light, thus extremely bright. With ABE.
Taillight version STRING:
120mm wide, 10mm high LED taillight adapted to the frame radius, form-fitted into the rear frame. Of course also with integrated brake light. With ABE.
If you have an overhead exhaust system (e.g. original Scrambler, or accessories such as Unit Garage e.t.c.), we also have a suitable exhaust holder in the program. ( see accessories )
The rear frame is made of steel. We bend the round tube from one piece and weld it in a welding jig with the lasered and edged retaining plates.
For the rear lights we make housings, which are embedded in the frame loop and also TIG welded. After grinding these welds, the frame gets a durable black satin powder coating as a finish.
The bottom plates are laser-cut from 2mm thick aluminum sheets, then the brackets for the electronic components are riveted on and the threaded rivets for the turn signal brackets are inserted. These are also powder coated in the same black as the frame.
